Naturally tumbled pebbles and a specifically formulated cement are combined with water and additives, then pneumatically applied to the interior of the pool. Using a unique method, the mix is then hand troweled and "exposed" with precise timing to reveal the top layer of pebbles. After the finish has thoroughly hardened, (normally within 24 hours) it is cleaned with a solution to enhance the brightness and luster of the natural pebbles.

TRAINING

To maintain the highest possible level of quality, Pebble Tec is only available through licensed contractors who have been carefully selected, trained and authorized by Pebble Tec. Each craftsman receives extensive field training. Education continues with regional infield training.

ISN'T THE SURFACE ROUGH?

The pebbles used are finely screened and naturally tumbled which means that even though the surface is bumpy, it is not abrasive.

WHAT HAPPENS WHEN ALGAE GROWS ON THE PEBBLE TEC FINISH?

Algae will grow on anything, but because the pebbles are nonporous, the algae will not bond as readily to Pebble Tec as it does to plaster or marcite. That means it can be easily cleaned without damage to the surface.

DOES THE SURFACE COLOR VARY?

Because Pebble Tec is a natural product and hand finished, variations in color and exposure are to be expected. The variations throughout a Pebble Tec pool create a distinctly unique appearance...naturally.

WILL PEBBLES FALL OFF?

It is normal to experience a small loss of pebbles for a short period of time after pool start ups. Don't worry, there are approximately 42 million pebbles in your pool!

WHAT IS THE WARRANTY?

Pebble Tec is installed only by authorized/licensed contractors who will provide a written warranty statement covering at least five (5) years.

HOW DO I TAKE CARE OF A PEBBLE TECŪ POOL?

Caring for a Pebble TecŪ pool is no different than caring for a plaster/marcite pool. The water chemistry should be maintained according to the "Saturation Index." The saturation index measures the various factors in the pool water, such as pH, alkalinity, hardness, etc. and adjusts them according to a specific formula depending on the levels of each factor. There is not a standard level at which each factor is always kept. Based upon the results of the computerized testing, recommendations will be made as to what needs to be added to, or deleted from your pool water.

If your pool builder does not provide this service, this type of balancing can be done at a local pool store that offers computerized water testing. For a dealer near you, check your local yellow pages or contact BioLab @ 1-800-998-7946 and choose the "BioGuard" option.

CLEANING THE "RING" AROUND THE POOL. If you have a pool or spa without waterline tile and need advice on removing the "ring" around the waterline of the Pebble Tec, the following instructions are basic guidelines.

This ring is commonly referred to as a "calcium ring" or "mineral buildup." Usually any type of cleaner designed to clean calcium off of waterline tile will also work on Pebble Tec. When using these cleaners/chemicals follow the directions on the container.

It is a good idea to spot test a small area first. Lower the water level to expose the waterline and apply the cleaner to an area of about 8-10". Next, scrub the area with a nylon brush and start rinsing with a hose while scrubbing. The cleaners can be rinsed into the pool, but remember to use caution while working with these chemicals as they may contain acids. Repeat as necessary. Always follow the instructions on the container.

Do not attempt to use Muriatic acid on the waterline ring as it will not work to remove this type of buildup.